PC-3

INFRARED MODULATED PHOTOEYE

  • Thru beam configuration
  • LED alignment indicator simplifies installation
  • No calibration or sensitivity adjustments needed
  • Wide sensing angle for increased reliability
  • 30 ft. operating range

PART NUMBERS:

  • EMX-1302-1: PC-3 – (RX & TX)

PC-3 Infrared Modulated Photoeye Overview

The PC-3 infrared modulated photoeye sensor is an easy-to-install, cost-effective safety device for garage doors and rolling doors.

When the infrared beam is interrupted, the relay common and normally open contacts in the receiver are closed. The LED indicator is lit when the PC-3 receiver is not aligned or when the beam is interrupted.

Features

  • Works with any control board that accepts dry contact in the safety input
  • Supervised relay output provides an “open” signal in case of power failure
  • Non-reflective thru beam configuration is not affected by shiny surfaces
  • Modulated infrared beam not affected by sunlight, rain, dust or dirt
  • Wide detection angle: 24 degrees
  • Indoor or protected outdoor operation of 30 feet

Specs

Range 30 feet
Power 12V – 24V AC or DC
Relay Contacts 1A @ 24VDC or 120VAC
Dimensions 4 in. x 2 in. x 1.5 in. 18” lead wire
Housing Black PVC * Not water tight

IRB-BR
Steel “L” shaped mounting bracket
3″x2″x9″, set of 2

Spec Sheet

Manual

You may also like...

Have Any Questions ?

Have questions or need pricing on one of our products?